2,187
edits
Difference between revisions of "Vyatta"
Jump to navigation
Jump to search
m
Added "Firewall"
m (Added firewall example) |
m (Added "Firewall") |
||
| Line 16: | Line 16: | ||
#* Accept all defaults | #* Accept all defaults | ||
# Reboot and disconnect ISO | # Reboot and disconnect ISO | ||
# Login and run following commands to set IP | # Login and run the following commands to set IP address and default gateway | ||
#* <code> configure </code> | #* <code> configure </code> | ||
#* <code> set interfaces ethernet eth0 address 192.168.1.10/24 </code> (repeat for other interfaces) | #* <code> set interfaces ethernet eth0 address 192.168.1.10/24 </code> (repeat for other interfaces) | ||
#* <code> set system gateway-address 192.168.10.1 </code> | |||
# Enable remote ssh access | # Enable remote ssh access | ||
#* <code> set service ssh </code> | #* <code> set service ssh </code> | ||
| Line 36: | Line 37: | ||
== Configuration == | == Configuration == | ||
=== Basic Commands === | |||
In similar fashion to Cisco IOS, configuration has to be entered in config mode, and the configuration can only be viewed in Operator mode. | |||
=== Firewall === | === Firewall === | ||
If an interface has no firewall config, then it passes all traffic. Once any firewall config is applied then that interface acts as a firewall. | If an interface has no firewall config, then it passes all traffic. Once any firewall config is applied then that interface acts as a firewall. | ||