VCP5

This page shows my crib notes created into to obtain the VCP5 certification. I've been using the technology for a while now, and I've only bothered to document the gaps in my own knowledge, so it is by no means concise and unlikely to cover much that would also apply to previous certs. VMware's What's New course covers the following...

• List and describe key enhancements in vSphere 5.0
• Upgrade a deployment from vSphere 4.x to vSphere 5.0
• Use Image Builder to modify and export an image profile as part of Auto Deploy
• Use Auto Deploy to Install a stateless ESXi host
• Manage a version 8 virtual machine with the next-generation Web-based VMware vSphere Client
• List and describe key networking enhancements, including the ESXi firewall and new features in vNetwork distributed switches
• Upgrade and manage a VMware vSphere VMFS5 datastore
• Understand and configure policy-driven storage management
• Create a datastore cluster and configure Storage DRS
• Configure a VMware High Availability cluster based on the new Fault Domain Manager agents
• Use the Linux-based VMware vCenter Server Appliance

Plan, Install, Configure and Upgrade vCenter Server and VMware ESXi

Install and Configure vCenter Server

vCentre Server Appliance

• Deployed via OVF, requires 7 GB disk (max 80 GB)
• Supports up to 5 ESXs / 50 VMs with embedded db

vCentre Server Components

• Web Client (Server)
• Update Manager - requires 32-bit DSN db
• ESXi Dump Collector - requires IPv4
• Syslog Collector - requires IPv4
• Auto Deploy - deploys ESXi image direct to ESX memory
• Authentication Proxy - allows ESXi servers to join AD domain

vCentre Availability

• Must match any requirements to support Auto Deploy
• Must run on ESXi's not supported by Auto Deploy

Client version use cases

• vSphere Client - Primary vSphere management tool (for infrastructure sys admins)
• vSphere Web Client - Primarily intended for inventory display, and VM deployment/configuration (for infrastructure mgrs and consumers)

Install and Configure VMware ESXi

vSphere Auto Deploy Image Builder

• Creates ESXi images in VIB packages

Auto Deploy rules

• Rules identify an ESX by...
  • boot MAC (as seen in PXE boot)
  • SMBIOS info
  • BIOS UUID
  • Vendor / Model
  • Fixed DHCP IP address
• Active Rule Set - used to match ESXs at boot time
• Working Rule Set - used test compliance prior to adding to rule to Active Rule Set

On an ESX's 1st boot

1. ESX boots, gets IP from DHCP server
2. ESX downloads and runs gPXE from TFTP server
3. gPXE gets image from Auto-Deploy server over HTTP
4. ESX boots image and registers with VC that the Auto Deploy server is registered with
5. If Host Profile requires user entry, ESX will boot into Maintenance Mode
6. If ESX is part of DRS cluster, ESX may receive VM's as soon as online

Memory Compression Cache

• Mem.MemZipEnable - set to 0 to disable
• Mem.MemZipMaxPct - changes %age of VM memory allowed to be compressed (default is 10%)

Plan and Perform Upgrades of vCenter Server and VMware ESXi

ESX

• ESX's can be upgraded via (ESX will retain MS-DOS based partitioning)
  • Update Manager
  • ISO installer
  • Script
• Or installed fresh via (ESX will use GUID partition tables)
  • esxcli
  • Auto Deploy (not an upgrade, ESX is re-provisioned from scratch)
  • ISO installer

VMFS

• v3 -> v5 Upgrade...
  • Requires exclusive access to datastore
  • Original block size is retained

Secure vCenter Server and ESXi

Role	Type	ESX / VC	Description
No Access	System	ESX & VC	No view or do. Can be used to stop permissions propagating.
Read Only	System	ESX & VC	View all except Console, no do.
Administrator	System	ESX & VC	Full rights
VM User	Sample	VC only	VM start/stop, console, insert media (CD)
VM Power User	Sample	VC only	As user plus hardware and snapshot operations
Resource Pool Admin	Sample	VC Only	Akin to an OU admin, full rights for child objects Cannot create new VM's without additional VM and datastore privileges.
Datastore Consumer	Sample	VC Only	Allows creation of VMDK's or snapshots in datastore (additional VM privileges to action)
Network Consumer	Sample	VC Only	Allows assignment of VM's to networks (additional VM privileges to action)

vCentre Access

• Disabled logged in users use access as next validation period (default is 24hrs)

ESXi Firewall

• New for v5
• Rule set XML files found in /etc/vmware/firewall/
• Should be edited via GUI

ESXi and Active Directory

• ESX FQDN must match AD domain
• ESX and AD should be synced to same time
• ESX's DNS must be able to resolve the AD domain
• Add to OU container using domain name format
  • sandfordit.local/SiliconOU1/MondeoOU2

Identify vSphere Architecture and Solutions

vSphere Editions

Edition	vRAM	vCPU/VM	Features
Essentials	32 GB	8 vCPU	Max 3 ESX's with 2 CPUs each, managed by vCentre for Essentials
Essentials Plus	32 GB	8 vCPU	+ HA, Data Recovery, vMotion
Standard	32 GB	8 vCPU	HA, Data Recovery, vMotion
Enterprise	64 GB	8 vCPU	+ DRS, DPM, SvMotion, FT, Hot Add, vShield
Enterprise Plus	96 GB	32 vCPU	+ dvSwitch, IO Control, Host Profiles, Auto-Deploy, sDRS
Desktop	n/a	??	VDI only

Public Clouds

• Service Offerings
  • Basic - Pilot projects etc, pay-for-use
  • Commited - Reserved allocation (subscription for resources)
  • Dedicated - Dedicated hardware, aka virtual private cloud

Private Cloud

• Workloads
  • Transient - temporary, suitable for pay as you go allocation pool model
  • High Elastic - dynamic (customer led), suitable for allocation pool model
  • Infrastructure - core services such as AD, print, email, etc, suitable for reservation pool model
• Service Tiers
  • Premium - infrastructure and high perf workloads
  • Standard - highly elastic workloads
  • Development

Plan and Configure vSphere Networking

Configure vNetwork Standard Switches

• vSS - vNetwork Standard Switch (vSwitch)

Configure vNetwork Distributed Switches

• vDS - vNetwork Distributed Switch (dvSwitch)

Load Balancing

• Route based on originating virtual port
• Route based on IP hash - Must be used if using EtherChannel
• Route based on source MAC hash
• Route based on physical NIC load - Must used for I/O Control
• Use explicit failover order

Configure vSS and vDS Policies

• TCP Segmentation Offload - Replace VM's NIC with Enhanced vmxnet
• NetFlow is available for dvSwitch (vDS requires its own IP address)

Plan and Configure vSphere Storage

Configure Shared Storage for vSphere

• Max no of storage paths per ESX - 1024
  • Max no of VMFS per ESX - 256
• Max no of software FCoE adapters - 4

iSCSI Adapters

• Software Adapter - ESX software implementation using VMkernel
• Dependant Hardware Adapter - Standard NIC with iSCSI offload functionality, reliant on ESX's networking
• Independent Hardware Adapter - Full iSCSI card, not reliant on ESX networking

Boot from software iSCSI now supported. If disabled, adapter re-enables for boot.

Storage I/O Control

Allows VM's to be set storage IO shares and IOPS limits that take effect when datastore latency becomes too great (30ms by default)

• Requirements
  • Datastores must be managed by single VC
  • Fibre Channel, iSCSI, or NFS storage (RDMs bot supported)
  • Single extents
  • SAN's with automated storage tiering must be certified compatible with Storage I/O

Configure the Storage Virtual Appliance for vSphere

Allows 2 or 3 ESX's local storage to pooled together into a virtual datastore

• VSA - vSphere Storage Appliance - deployed to each ESX providing storage to VSA cluster
  • Cannot be deployed to ESX that also host vCentre
  • Has 3 IP addresses (mgmt, datastore, backend/replication)
• ESX
  • Must have static IP on same subnet as vCentre
• Disks
  • 2, 4 or 8 identical disks (same model & capacity, JBOD not supported)
  • Must be in RAID10 on ESX, then RAID1'ed by VSA to another ESX
• VMs
  • Cannot running on ESX prior to VSA cluster creation
  • Running on VSA datastores cannot swap memory, use memory reservations

Create and Configure VMFS and NFS Datastores

VMFS5

• Supports > 2TB per extent, max 64 TB datastore size
• Supports > 2TB RDM
• Max VMDK size is 2TB less 512B
• 1 MB block size
• Uses hardware assisted ATS (Atomic Test and Set) locking where available
  • Instead of SCSI reservations, locks disk sector rather than whole disk

VMFS3 -> VMFS5 Upgrade

• VM downtime not required

Deploy and Administer Virtual Machines and vApps

Create and Deploy Virtual Machines

VM hardware version in now v8, but may be v7 if

• VM migrated from ESX v4
• Use a virtual disk created on ESX v4 in a VM

Administer Virtual Machines and vApps

Memory Overhead - Amount of determined by

• No of vCPU's
• Configured memory

SplitRx

• Allows multiple ESX CPU's to process incoming network traffic for a VM
• Requires VMXNET3 adapter
• Enabled in VMX/Config Parameters
  • ethernetX.emuRxMode set to 1 (eg use ethernet1 for NIC 1

VMX Swap - VM Executable swap

• Allows part of the VM memory overhead to swapped to disk (saves 10 - 50 MB ESX RAM per machine)

vMotion

• vCentre tries to reserve resources on source and dest ESX's, shared by concurrent vMotions
• Migrations always proceed (> ESX 4.0, otherwise not if resources cannot be reserved)

Establish and Maintain Service Levels

Create and Configure VMware Clusters

High Availability Now uses Fault Domain Manager (FDM) agent rather than AAM

• 1 master host, remaining ESX's are all slaves
• Uses both network and datastore heartbeating as a fallback should network isolation occur
• Reliant on vCentre for reconfiguration (only)
• Communication by IP (not DNS!)
• Logs to standard syslog

In the case of network problems an ESX will be either of;

• Isolated ESX - No mgmt network connectivity to any other ESXs in cluster
• Partitioned ESX - Lost connectivity to master, but can see other ESX's
  • One ESX in partition will be elected as master

Plan and Implement VMware Fault Tolerance

Unsupported

• Snapshots
  • Therefore also Storage vMotion, VM backups, and Linked Clones
• SMP - Only single vCPU supported
• Physical RDM (virtual OK)
• Thin disks (must be eager-zeroed/support cluster features)
• NPIV
• IP v6
• NIC Passthrough
• Hot-plug devices
• Paravirtualised guests
• CD-ROM attached ISO not on shared storage

Limitations / Requirements

• DRS EVC must be enabled
  • VM's can be hosted, but won't be automated by DRS in non-EVC cluster
• Max 4 FT VMs per ESX
  • Override via das.maxftvmsperhost
• Max 64 GB per VM